ATLANTIC Anchor bracket for Bruce/Delta anchors, stainless stell

The Atlantic anchor brackets for Bruce and Delta anchors are very popular around the world. Two models are available: the 3-10 kg and  10-20 kg  models cover almost the entire range of anchors reasonably attachable to railing.

The brackets can be attached to vertical-inclined or horizontal pipes. It is also possible to attach the top end to a horizontal pipe and the bottom end to a vertical pipe. Wall mounting is possible as well. You only need to remove the detachable half of the bracket clamp and screw the stationary clamp half to the wall through the clamp holes. If the screws are likely to penetrate the wall, remember to use a back plate for support.

Railing pipe diameter: 22-30 mm. The anchor hangs on the bracket by the shackle in the eye. The bottom end is supported by a fork made of durable plate and equipped with a tensioning screw for ensuring that the anchor stays in its place without clinking even in stormy weather or when using the engine.

Installation is also possible on two horizontal pipes, if the distance between the pipes is 150-350 mm.
In case of brackets intended for 15 kg anchors, vertical steel supports (diameter 12 mm) are used; in case of the smaller model, the supports are made of 8 mm stainless steel. 10 mm stainless screws are used in the fasteners.

Dimensions:
AB-000310: Length 450 mm, max. inside width top 14 mm, max. inside width bottom (anchor shaft) 40 mm, weight 1.20 kg
AB-001020: Length 500 mm, max. width inside top 22 mm, max. width inside bottom (anchor shaft) 40 mm, weight 1.95 kg